1. Mold striped-gari or out but the color faded odd
Analysis of the cause:
a. Adanyan void space in Cartridge (air bubbles in the cartridge) that is caused when we enter the ink is not careful
b. Print head is clogged by the ink possibility of drought because it is not often used (can be caused by rarely used)
c. Print head is damaged / scratched / position changed due to physical damage
d. One of the cartridge installation
e. There are running out of ink for certain color or everything
f. One of the settings in the computer
solution:
a. Clean by performing head cleaning for 2-4 times to remove air bubbles inside the cartridge by opening the properties of the printer.
b. Go and wash its cartridges when the ink splattered and Replace correctly catridenya, turn off and turn it back to meyakinakan that cartridge status has changed.
c. Replace the old cartridge / damaged
d. Keep absolutely not to open / open seal while the output movie striped bottom out or not at all
e. Check and make sure when you print is not in a draft print quality setting or super economy
f. Replace the old print head or damaged
2. Print is not out at all
Analysis of the cause:
Many air bubbles in the cartridge
a. The printer is too old or damaged or closed part of its print head
b. Label color (yellow) is not disposed
solution:
a. Clean by performing head cleaning for 2-4 times to remove air bubbles inside the cartridge by opening the properties of the printer.
b. Shake the cartridge a few times (3-4) before installing
c. Remove the yellow label so that air can flow to print normally
d. Keep absolutely not to open / open seal while the output movie striped bottom out or not at all
3. The printer does not recognize a new cartridge is installed
Analysis of the cause:
a. Cartridge not installed correctly
b. Touching a small chip on the cartridge with the hand or the chip also dirty / wet (chip is prone to damage)
c. Damage to the track portion (circuit on the cartridge)
solution:
a. Replace catridenya and make sure the correct position, turn off and turn it back to meyakinakan setatus cartridge that has changed.
b. Use and dry cleaning wipes to clean the chip when the chip is dirty in a dirty state.
c. Checks rangkaiannnya track if something is broken
d. If that is not possible then replace any tuk repaired with a new one.
4. Once the new cartridge is installed there is a warning that the cartridge installed is not genuine
Analysis of the cause:
a. This can be caused because when we replace the printer cartridge positions are switched off, so the printer memory is still in a state before “the ink runs out
The solution:
This message just ignore them if you have any questions just answer “yes” or intervenes on demand, this case does not affect the quality of the print with the printer
5. The printer can not print
At the time of the printing process will be done, the printer in the ON state (life), and the paper has been installed correctly but it will not move and the printing process is declared unsuccessful. To fix the procedure is as follows.
a. Testing the printer using print a test page on the printer driver.
b. To do so can through the stars >> settings >> printers. Then right click on the printer and select Properties, in the General tab, click the button print a test page.
a. If after the button is press, the printer can print means no problem with the printer.
b. If not, then there masaalh on the printer or the printer port connection. Try it on another computer, if the printing process is successful means that the damage is not on the printer but on the printer port.
c. If the printing process fails there is a problem in the printer. To overcome this problem try to check the printer from the cartridge to connect the wires.